Jon Marshall Wed, 10/29/2008 - 12:37
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

"switchport host" is the command you are looking for. It doesn't take an argument but in conjunction with the "interface range.." command it is close to what you want eg.


switch(config)# int range fa0/1 - 10

switch(config-if)# switchport host


http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_46_se/command/reference/cli3.html#wp1948119


Note that not all switches necessarily support it.


Jon

glen.grant Wed, 10/29/2008 - 14:53
User Badges:
  • Purple, 4500 points or more

Almost all newer switches from 2950's up support the switchport host command , use it all the time .

Actions

This Discussion