Air Bridge 1310 - Configuring QOS on Point to Point

Unanswered Question

I have 2 BR1310 Air Bridge's configured for a point to point connection, one is root,one is non-root. In configuring QOS for VOIP for the first time, I'm looking for a best practice configuration.

Behind each bridge is a 3560 switch that has QOS configured on each switchport. Our environment consists of 7960 desk phones.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Thu, 10/30/2008 - 09:28
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Michael,


Have a look at these docs. Hopefully they will help get you started;


Cisco Aironet 1300 Series Outdoor Access Point/Bridge Software Configuration Guide, 12.3(4) JA


Chapter 14 - Configuring QoS


This chapter describes how to configure quality of service (QoS) on your access point/bridge. With this feature, you can provide preferential treatment to certain traffic at the expense of others. Without QoS, the access point/bridge offers best-effort service to each packet, regardless of the packet contents or size. It sends the packets without any assurance of reliability, delay bounds, or throughput.


From this doc;


http://www.cisco.com/en/US/docs/wireless/access_point/1300/12.3_4_JA/configuration/guide/o13qos.html


Giving Priority to Voice Traffic


This section demonstrates how you can apply a QoS policy to your wireless network's voice VLAN to give priority to wireless phone traffic.


In this example, the network administrator creates a policy named voice_policy that applies voice class of service to traffic from Spectralink phones (protocol 119 packets). The user applies the voice_policy to the incoming and outgoing radio ports and to the outgoing Ethernet port for VLAN 77.


Use the Apply Policies to Interface/VLANs drop-down menus to apply policies to the access point Ethernet and radio ports. If VLANs are configured on the access point, drop-down menus for each VLANs' virtual ports appear in this section. If VLANs are not configured on the access point, drop-down menus for each interface appear.


From this doc;


http://www.cisco.com/en/US/docs/wireless/access_point/1300/12.3_4_JA/configuration/guide/o13qos.html#wp1047736



Hope this helps!

Rob


Actions

This Discussion