Upgradation of flash

Unanswered Question
Oct 29th, 2008
User Badges:

Hi,


While upgrading Flash on router it goes into rommon mode. How can I back into router mode?

I use command confreg 0x2101 and reset but int again goes into rommon mode.


Please help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kalshetty Wed, 10/29/2008 - 23:01
User Badges:

Hi,


It saying that Input redirection is not supported at this level.

bagvanliju Thu, 10/30/2008 - 00:31
User Badges:

Hai,



Are you sure that ios is transferd sucfly to Flash ..?? if so ...


...when are you getting this error ???


rommman>confreg 0x2102

romman> reset



ujil


kalshetty Thu, 10/30/2008 - 03:46
User Badges:

Hi Ujil,


When I set the configuration register to 0x2102. And then set the boot path from the rommon using " BOOT:=bootflash:,

it gives that error.


And how I know that ios is transferd sucfly to Flash?

When I put command dev it shows flash but I put command dir flash it shows error that bad device name.

bagvanliju Thu, 10/30/2008 - 04:10
User Badges:

hai,


I suspect ios is not properly tranfrd ,,,,can u try uploading the ios once again ...via console and see the status ....


Guys correct me if i am wrong


ujil

patrickvanham Thu, 10/30/2008 - 04:28
User Badges:

rommon mode is a bit more sensitive than the IOS prompt. try using "dir FLASH:" (without quotes). Redirect implies you actually use "" when using boot. Is this assumption correct?

kalshetty Thu, 10/30/2008 - 20:20
User Badges:

Hi,

When I put the command dir flash, it shows error that bad device name.

I think router's flash is corrupted.

Pleae educate me on this issue.

kalshetty Thu, 10/30/2008 - 23:29
User Badges:

Hi,


Thanks. It's done by downloading a software image via TFTP using the tftpdnld ROMMON ommand.




Actions

This Discussion