valdemar2008 Thu, 10/30/2008 - 04:25
User Badges:

Please, give the examples on serieses CISCO 800 for decision of my problem. Thank!

valdemar2008 Tue, 11/18/2008 - 22:14
User Badges:

Used the bridge, all work.

--------------------------

Command Task

Step 1 no ip routing Disable IP routing.

Step 2 bridge 1 protocol ieee Specify the bridge protocol to define the type

of Spanning-Tree protocol.

Step 3 interface ethernet 0 Enter configuration mode for the Ethernet

interface.

Step 4 bridge-group 1 Specify the bridge-group number to which the

Ethernet interface belongs.

Step 5 no shutdown Enable the Ethernet interface.

Step 6 exit Exit configuration mode for the Ethernet

interface and the router.

Step 7 interface ATM 0 Enter configuration mode for the ATM

interface.

Step 8 pvc 8/35 Create an ATM permanent virtual circuit

(PVC) for each end node with which the

router communicates.

Step 9 encapsulation aal5snap Specify the encapsulation type for the PVC.

Step 10 bridge-group 1 Specify the bridge-group number to which the

ATM interface belongs.

Step 11 no shutdown Enable the ATM interface.

Step 12 exit Exit configuration mode for the ATM

interface.

Chapter 4 Network Scenarios

Internet Access Scenarios

4-12

Cisco 800 Series Software Configuration Guide

78-5372-06

Configuration Example

The following is a configuration example for this network scenario. You do not

have to enter the commands marked “default.” These commands appear

automatically in the configuration file generated when you use the show

running-config command.

no ip routing

!

interface Ethernet0

no ip address

no ip directed-broadcast (default)

bridge-group 1

!

interface ATM0

no ip address

no ip directed-broadcast (default)

pvc 8/35

encapsulation aal5snap

!

bridge-group 1

!

ip classless (default)

!

bridge 1 protocol ieee

!

end


Actions

This Discussion