Config-Register 0x0 for feature boards

Unanswered Question
Oct 30th, 2008

I need to understand what config-register for 0x0 actually means for feature boards.

The Cisco explanation states:

Setting the configuration register to 0x0 will prevent the feature boards from booting when the controller card is rebooted.

Does that mean that the feature board will not come up at all or stay up with no microcode upload done?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion