routing policy ip reachability

sgtbilko711 · ‎10-30-2008

I am looking to set up a ip reachability policy. I have never dont it before and am looking information on it either by you telling me or someone showing me were good documintation is on this.

Thanks

Chris

Jon Marshall · ‎10-30-2008

Chris

Is this what you are looking for ?

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN,%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB?cmd=display_location&location=.2cc2316a

Jon

sgtbilko711 · ‎10-30-2008

Jon

Ok it looks right but let me run this by you.

If i have traffic going out one ip interface on a router and i have the 6500 check to see if it is up. whn it goes down i want to send it to a new ip interface.

looking over the doc. it looks like it but i am not sure.

Amit Singh · ‎10-30-2008

Here is a test config that I had setup to check the same stuff. The toplogy that I used was like R1 --> R2 and R3 and both R2 and R3 inturns connect back to R4.

R2-----

R1--- R4

R3-----

The test was to use IPSLA and object tracking to fail-over the traffic from R1 to either of the connection in case of an indirect failure in the connectivity. I was pinging the R4 loopback addresses from R1 and tried shutting down the R2 and R3 link to R4.

HTH, Please rate if it does.

-amit singh