10-30-2008 09:00 AM - edited 03-06-2019 02:13 AM
I am looking to set up a ip reachability policy. I have never dont it before and am looking information on it either by you telling me or someone showing me were good documintation is on this.
Thanks
Chris
10-30-2008 09:57 AM
10-30-2008 10:10 AM
Jon
Ok it looks right but let me run this by you.
If i have traffic going out one ip interface on a router and i have the 6500 check to see if it is up. whn it goes down i want to send it to a new ip interface.
looking over the doc. it looks like it but i am not sure.
10-30-2008 10:27 AM
Here is a test config that I had setup to check the same stuff. The toplogy that I used was like R1 --> R2 and R3 and both R2 and R3 inturns connect back to R4.
R2-----
R1--- R4
R3-----
The test was to use IPSLA and object tracking to fail-over the traffic from R1 to either of the connection in case of an indirect failure in the connectivity. I was pinging the R4 loopback addresses from R1 and tried shutting down the R2 and R3 link to R4.
HTH, Please rate if it does.
-amit singh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: