WLC 526 port config

Unanswered Question

Hi All

Having installed a WLC 526 for a small school I have assumed that the ports were similar to those on the 2100 etc. However whenever port 2 is cabled the WLC dies.

The setup is a flat layer 2 domain WLC with 5 aps connected. All connected via a linksys switch. No VLANs so no tagging. Everything works fine via port 1, ap-manager and managemnet set to port 1 but as soon as port 2 connected it all sits down and the aps disconnect. I am thinking its something I am overlooking?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dennischolmes Fri, 10/31/2008 - 05:19

What were you going to use port 2 for? It can't be LAGGED as this unit only support 100mb throughput. The 526 doesn't support redundant connections either via a code switch. The 526, even though LWAPP, does not have all the features of the full blown Enterprise LWAPP controllers.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode