Root AP and spanning tree configuration

Unanswered Question
Oct 30th, 2008
User Badges:

I'm using AIR-LAP1522AG-A-K9 and Enterasys switch.

How should it be the spanning tree configuration in the ports where are connected the Root Access Points

STP should be enabled or disabled?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Thu, 10/30/2008 - 12:10
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

I have never had to enable spanning tree on any access point. Leave that alone unless you require it for some odd reason... like in this doc:

c.delcarpio Thu, 10/30/2008 - 16:56
User Badges:

How could i prevent loops between the wired switch and the radio A when i have two RAPs connected to the same switch and one of them loss connection with the ethernet interface for a while


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode