10-30-2008 11:13 AM - edited 07-03-2021 04:42 PM
Hi all, i have a WLSE 2.15.2 and AP 1100 12.3(JEB), the state of the AP NM status is authenticated instead of security keys setup, they know because can be?, by this razon apparently does not send the AP the messages of RM to the WLSE, thanks.
11-05-2008 09:31 AM
Can you try to Enable *all* radio interfaces so that they're "up" in the "show ip interfaces brief" and then redo the inventory on the WLSE. Leave them up until the wlccp link comes to "SECURITY_KEYS_SETUP". Once it comes to that state, you can shut down the radio interface.Even after a reload, the SECURITY_KEYS_SETUP will remain.To expedite the process, run a Discovery job on the AP.
12-04-2008 03:33 AM
Hi,
here is a link to a reported bug in ACS 3.3.3. Check if that applies to your case.
Regards,
V
12-04-2008 05:20 AM
Thank you so much for its aid, finally carry out upgrade of ACS 3.3.3 to 4,0 since find not just then this BUG. Greetings.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide