10-30-2008 02:02 PM - edited 03-11-2019 07:06 AM
Hi all
I have two ASAs configured in Active/standby failover in single context mode .Is it possible to configure failover such a way that when Primary unit comes up after filover, it becomes automatically active ?
Thanks in advance
10-30-2008 02:17 PM
Hi,
Preempt feature in Failover on the ASA is ONLY available in Active/Active Setup and not in Active/Standby. Please review the link below:
http://www.cisco.com/en/US/docs/security/asa/asa80/command/reference/p.html#
wp1840534
below is a link on Active/Active Failover:
http://www.cisco.com/en/US/products/ps6120/products_configuration_example091
86a0080834058.shtml
Regards,
Arul
*Pls rate if it helps*
10-31-2008 12:30 AM
Thanks Arul for the information and link
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: