IKE error between ASA 5510 and CISCO 3015

Unanswered Question
Oct 31st, 2008

Hi

I'm tryning to establish a L2L connection with a customer, my equipment is a ASA 5510 8.0(2)

After the command show isakmp sa, i have the following reply

Active SA: 1

Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)

Total IKE SA: 1

With a debug crypto isakmp 25

smbasa5510-01# Oct 31 11:39:26 [IKEv1 DEBUG]: Pitcher: received a key acquire message, spi 0x0

Oct 31 11:39:26 [IKEv1]: IP = 217.70.85.44, Queuing KEY-ACQUIRE messages to be processed when P1 SA is complete.

Oct 31 11:39:27 [IKEv1 DEBUG]: Pitcher: received a key acquire message, spi 0x0

Oct 31 11:39:27 [IKEv1]: IP = 217.70.85.44, Queuing KEY-ACQUIRE messages to be processed when P1 SA is complete.

Oct 31 11:39:29 [IKEv1]: IP = 217.70.85.44, IKE_DECODE RESENDING Message (msgid=0) with payloads : HDR + SA (1) + VENDOR (13) + NONE (0) total length : 152

Oct 31 11:39:29 [IKEv1 DEBUG]: Pitcher: received a key acquire message, spi 0x0

Oct 31 11:39:29 [IKEv1]: IP = 217.70.85.44, Queuing KEY-ACQUIRE messages to be processed when P1 SA is complete.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ajagadee Thu, 11/06/2008 - 18:39

Hi,

Can you check the Preshared Key on both the sides and make sure its the same.

Regards,

Arul

*Pls rate if it helps*

Actions

This Discussion