ASA5510 duplex mismatch

Unanswered Question
Oct 31st, 2008
User Badges:

I have an ASA5510 (7.2(4)) with outside interface conn to ISP's Cisco 2610 (10M Ethernet - NOT FASTETHERNET).

Previously a PIX506E was attached to same router. PIX outside was set 'interface ethernet0 10full' and the router's E0/0 was hard set 'full-duplex'.

This link functioned as desired at 10/FULL.

Now when I conn the ASA I cannot get the link to come up at full-duplex. The 2610 is running c2600-i-mz.123-19 IOS.

Any suggestions from the Cisco community?

Phil

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
srue Fri, 10/31/2008 - 07:14
User Badges:
  • Blue, 1500 points or more

hard code the asa to 10/full.


Actions

This Discussion