10-31-2008 07:57 AM - edited 03-15-2019 02:17 PM
We ordered a range of DID's. I want to test them out.
I have one example extension in our office. Ext. 280. Here is our DID range.
814-596-4000 through 4299
Attached is our config. We use h323 on a Business Call manager 6.
Please let me know if their is info here I am missing.
Thanks in advance.
10-31-2008 07:58 AM
10-31-2008 08:11 AM
simply configure the significant digits to 3 under the H323 GW in CUCM config and test this.
HTH
java
if this helps, please rate
10-31-2008 10:11 AM
I am unable to get to the user it goes to the receptionist. Currently if you call my client, it will go to the receptionist and then she will transfer the call. Is there something else I need to do to go directly to the user instread of going to the receptionist even though I am dialing the complete number with the last three of the user's extension.
10-31-2008 10:16 AM
Well you need to do what we told you before. If that is not happening then let's take a CCM detailed trace set to complex to see exactly what is going on with your call.
10-31-2008 08:16 AM
So, not sure what is your question here...
If you have that range you can setup a dial-peer to the CCM, then in the CCM on the GW config page setup under incoming calls just setup the digits that you which to accept, last 4 digits, last 3 digits, etc.
if you do not have the same extensions you can setup a Translation Pattern to change the last 3 digits of your DID to the extensions.
//Jorge
10-31-2008 10:20 AM
Jorge,
You pretty much answered my question, but i will attempt to do what you stated above, but what would be helpful, can you give me examples of the syntex of how to do the dial peer and walk me through updating the translation pattern.
10-31-2008 10:27 AM
dial-peer voice 81 voip
description **** INCOMING CALLS TO CCM ****
destination-pattern 8145964[0-2]..
session target ipv4:192.168.100.2 (replace with your CCM's IP Address)
dtmf-relay h245-alphanumeric
Then on the significant digits (GW config page in CCMAdim webpage) if you are using 3 digits extensions then just use 3 digits.
Then create a Translation Pattern. On the Translation Pattern field you will put 2XX, then under called party transform mask you must put the actual extension range. Make sure to assign a CSS that can reach the DN's partition.
02-16-2009 06:02 PM
Hi
DI you solve your problem?
What is your Operator number
How did you configured it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide