WCS and Exclusion Area in planner mode

Unanswered Question
Oct 31st, 2008

I'm noticing in WCS that I can set a exclusion area, and the planner will put a AP in that area. Does planner not pay attention to exclusion areas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
krishanmistry Sun, 11/02/2008 - 00:48

Have you resynchronised the network plan with your location appliance or MSE after creating the inclusion zone. If you have and that doesn't work it may be worth unassigning the network plan from the Loc Ap, resynching with WCSand then assigning the network planback to the Loc ap and resynch.

Good look


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode