Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
359
Views
0
Helpful
4
Replies

PRI busy channles

Go to solution
ggittins
Level 1
Level 1

‎10-31-2008 09:00 AM - edited ‎03-15-2019 02:17 PM

is there a command to look at channels that are busy and is there a command under the ios to take them of busy

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Kenneth Mohammed
Level 7
Level 7
In response to ggittins

‎10-31-2008 09:05 AM

Im not sure if there is a command to reset individual channels, but you can bounce the PRI as a whole by doing a shut/no shut on controller t1 x/x/x, voice-port x/x/x:23, and interface serial x/x/x:23.

Hope that helped, if so please rate.

View solution in original post

0 Helpful
4 Replies 4

Go to solution
Kenneth Mohammed
Level 7
Level 7

‎10-31-2008 09:02 AM

Hello,

If you issue a "show isdn service", it will show you the status of the channels of your PRI.

Hope that helped, if so please rate.

0 Helpful

Go to solution
ggittins
Level 1
Level 1
In response to Kenneth Mohammed

‎10-31-2008 09:03 AM

thanks is there a command to reset a channels

0 Helpful

Go to solution
Kenneth Mohammed
Level 7
Level 7
In response to ggittins

‎10-31-2008 09:05 AM

Im not sure if there is a command to reset individual channels, but you can bounce the PRI as a whole by doing a shut/no shut on controller t1 x/x/x, voice-port x/x/x:23, and interface serial x/x/x:23.

Hope that helped, if so please rate.

0 Helpful
Customers Also Viewed These Support Documents