DHCP option 82 in WLC526

Unanswered Question
Nov 1st, 2008
User Badges:

I needed to use DHCP option 82 in my wireless network, but I can't enable this option on WLC526. DHCP proxy enable, auto-anchor mobility is not supported. But I still have in show run-config this:

DHCP Option 82..................Disabled


Could you advise me anything?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
owillins Thu, 11/06/2008 - 19:39
User Badges:
  • Silver, 250 points or more

Please reconfigure the Device.

config interface dhcp

To configure DHCP options on an interface, use the config interface dhcp command.

config interface dhcp {

ap-manager [primary dhcp_server secondary dhcp_server | option-82 [enable | disable] ] |

management [primary dhcp_server secondary dhcp_server | option-82 [enable | disable] ] |

service-port {enable | disable} |

interface-name name [primary dhcp_server secondary dhcp_server | option-82 [enable | disable] ]}

Examples

> config interface dhcp ap-manager server-1 10.21.15.01 server-2 10.21.15.25

> config interface dhcp ap-manager option-82 enable

> config interface dhcp service-port enable


tsarycheva Thu, 11/06/2008 - 21:40
User Badges:

Thank you for the answer.

Unfortunately I haven't this command in WLC526's CLI. I suppose that reason following:

"The WLC526 controller is simple to install and operate; therefore, the controller CLI consists of a limited number of primarily show and debug commands." (extract from Cisco 500 Series Wireless Express Mobility

Controller Configuration Guide).


These commands available:

(Cisco Controller) > config ?

advanced Advanced Configuration.

(Cisco Controller) >config advanced ?

802.11a 802.11a parameters.

802.11b 802.11b parameters.

client-handoff Auto handoff the clients on excessive retires.

dot11-padding Configure over-the-air frame padding

eap EAP (Extensible Authentication Protocol) Settings

macfiltering Configure advanced macfilter settings.

max-1x-sessions Maximum 802.1x session initiation per AP at a time.

probe-limit Limit number of probes sent to switch per AP slot per client in a given interval.

rate Enable/Disable switch control path rate limiting.

statistics Enable/Disable switch port statistics.

timers Configures system timers.


Mini IOS Version.............................3.0.51.0


IOS Version...........................12.4(10b)JX



vitorssouza Mon, 05/24/2010 - 11:48
User Badges:

Did you solve your problem? is that I am having the same problem.

Actions

This Discussion