cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
800
Views
0
Helpful
3
Replies

DHCP option 82 in WLC526

tsarycheva
Level 1
Level 1

I needed to use DHCP option 82 in my wireless network, but I can't enable this option on WLC526. DHCP proxy enable, auto-anchor mobility is not supported. But I still have in show run-config this:

DHCP Option 82..................Disabled

Could you advise me anything?

3 Replies 3

owillins
Level 6
Level 6

Please reconfigure the Device.

config interface dhcp

To configure DHCP options on an interface, use the config interface dhcp command.

config interface dhcp {

ap-manager [primary dhcp_server secondary dhcp_server | option-82 [enable | disable] ] |

management [primary dhcp_server secondary dhcp_server | option-82 [enable | disable] ] |

service-port {enable | disable} |

interface-name name [primary dhcp_server secondary dhcp_server | option-82 [enable | disable] ]}

Examples

> config interface dhcp ap-manager server-1 10.21.15.01 server-2 10.21.15.25

> config interface dhcp ap-manager option-82 enable

> config interface dhcp service-port enable

Thank you for the answer.

Unfortunately I haven't this command in WLC526's CLI. I suppose that reason following:

"The WLC526 controller is simple to install and operate; therefore, the controller CLI consists of a limited number of primarily show and debug commands." (extract from Cisco 500 Series Wireless Express Mobility

Controller Configuration Guide).

These commands available:

(Cisco Controller) > config ?

advanced Advanced Configuration.

(Cisco Controller) >config advanced ?

802.11a 802.11a parameters.

802.11b 802.11b parameters.

client-handoff Auto handoff the clients on excessive retires.

dot11-padding Configure over-the-air frame padding

eap EAP (Extensible Authentication Protocol) Settings

macfiltering Configure advanced macfilter settings.

max-1x-sessions Maximum 802.1x session initiation per AP at a time.

probe-limit Limit number of probes sent to switch per AP slot per client in a given interval.

rate Enable/Disable switch control path rate limiting.

statistics Enable/Disable switch port statistics.

timers Configures system timers.

Mini IOS Version.............................3.0.51.0

IOS Version...........................12.4(10b)JX

Did you solve your problem? is that I am having the same problem.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card