Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
314
Views
0
Helpful
1
Replies

IPS design question

alex goshtaei
Level 1
Level 1

‎11-02-2008 07:28 PM - edited ‎03-10-2019 04:21 AM

Hi All,

I have two ASA as active/standby failover. these two are connected to 3750 switch through trunk port that carry vlan 10,20 and 30. I want to deploy IPS in between with inline mode. I am little confuse how to connect IPS here. should it be connected with both two ports to switch, or it should be connected to ASA from one end and then connected to switch with another end.

If you show me how to connect IPS here, that would be very appreciated.

thanks

Alex

Labels:
0 Helpful
1 Reply 1

Farrukh Haroon
VIP Alumni
VIP Alumni

‎11-04-2008 04:35 AM

With inline vlan pair only one IPS interface is utilized (it has to be a trunk), have a look at:

http://www.cisco.com/en/US/products/sw/secursw/ps2113/products_configuration_example09186a0080876d9f.shtml

Regards

Farrukh

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card