Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
562
Views
0
Helpful
8
Replies

IS IT The looping

Go to solution
gandhi.ganesh
Level 1
Level 1

‎11-03-2008 03:40 AM - edited ‎03-04-2019 12:10 AM

Hi,

I am try to ping my remote site, in which we have Site to site VPN Tunnel betwee our office.

ping result is Reply from 192.168.103.254: TTL expired in transit. & please find the trace result

Labels:
Preview file
6 KB
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
andrew.prince
Level 10
Level 10
In response to gandhi.ganesh

‎11-03-2008 05:18 AM

You have to have you routing planned, you must decide how you want to route your traffic - static routes or dynamic routing.

Once you plan - then you implement.

HTH>

View solution in original post

0 Helpful
8 Replies 8

Go to solution
andrew.prince
Level 10
Level 10

‎11-03-2008 05:04 AM

Yes - you have a loop, you need to check the 2 layer 3 routing devices for overlapping config.

HTH>

0 Helpful

Go to solution
gandhi.ganesh
Level 1
Level 1
In response to andrew.prince

‎11-03-2008 05:07 AM

Yes,

You are right, can u please tell how to overcome this isssues in future

0 Helpful

Go to solution
andrew.prince
Level 10
Level 10
In response to gandhi.ganesh

‎11-03-2008 05:18 AM

You have to have you routing planned, you must decide how you want to route your traffic - static routes or dynamic routing.

Once you plan - then you implement.

HTH>

0 Helpful

Go to solution
gandhi.ganesh
Level 1
Level 1
In response to andrew.prince

‎11-03-2008 05:36 AM

Thx for ur time

0 Helpful

Go to solution
andrew.prince
Level 10
Level 10
In response to gandhi.ganesh

‎11-03-2008 05:46 AM

np - glad to help.

0 Helpful

Go to solution
gandhi.ganesh
Level 1
Level 1
In response to andrew.prince

‎11-03-2008 05:35 AM

Yes,

You are right, can u please tell how to overcome this isssues in future

0 Helpful

Go to solution
tcordier
Level 1
Level 1

‎11-03-2008 07:48 AM

Can you add the output of a show ip route on both the devices with IP address 192.168.103.1 and 192.168.103.254, and a show run for both devices?

- Thomas

0 Helpful

Go to solution
gandhi.ganesh
Level 1
Level 1
In response to tcordier

‎11-03-2008 08:47 PM

Andrew was right, there was a looping in my l3 switch(103.1).

I fixed the same

thx for ur reply

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card