Purge Management Issue in LMS 3.1 .

k_sinjish · ‎11-03-2008

Hi ,

We have configurted the purge setting as

Maximum version to retain : 10

Purge version older than : 30 days

in LMS 3.1 .

But while we are viewing the Version tree in the arecheve management we are getting around 30 numbers of running and startup instead of 10 .

But this issue is not there for all devices .

So please suggest how do we maintain this number as 10 .

Regards ,

sinjish.K

Joe Clarke · ‎11-03-2008

Make sure you are also doing ChangeAudit purging, retaining a similar amount of data. ChangeAudit purging is configured under RME > Admin > Change Audit > Set Purge Policy.

k_sinjish · ‎11-03-2008

Hi ,

Thanks for your update . We have set the purge policy also to 30 days now . But we could not see any change in the same .

Can you please suggest how do we proceed with the same .

Regards ,

sinjish.K

Joe Clarke · ‎11-03-2008

Make sure the Change Audit purge has run by going to Force Purge. Then wait for the config purge job to run again.

k_sinjish · ‎11-03-2008

We have done Force purge and run type as immediatly .Still puging is in the same way . We have seen the RME job as success in Job management also .

Regards ,

Sinjish.K

Joe Clarke · ‎11-05-2008

Enable Config Job debugging under RME > Admin > System Preferences > Application Loglevel Settings, then run another purge job. Post the log from the job directory.