PE-CE EIGRP redistrbution to M-BGP Problem

Unanswered Question
Nov 3rd, 2008
User Badges:
  • Bronze, 100 points or more

I'm using EIGRP as PE-CE routing protocol . Our customers are DSL's which are connecting on PE router as virtual interface .


The following is my PE config.


router eigrp 1

no auto-summary

!

address-family ipv4 vrf mpls-test

redistribute bgp 65000 metric 1000 100 255 1 1500

no auto-summary

autonomous-system 1

exit-address-family



router bgp 65000

address-family ipv4 vrf mpls-test

redistribute eigrp 1

no auto-summary

no synchronization

exit-address-family


DSL_Router1#sh ip vrf mpls-test

Name Default RD Interfaces

mpls-test 1:101 Lo3

Vi4551


On CE Router I did the basic EIGRP config , without neighbor statement as I can't do the neighbor with PPPoE Dialer interface . Is there is anyway in my case


Regards,

Haris



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Mon, 11/03/2008 - 10:12
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Haris,

in the EIGRP command reference I've found this suggestion:


VMI Interface Aggregation Point


see

http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_eig1.html#wp1012421


The VMI interface acts as an aggregation point for multiple PPPoE connections from one or more radios over one or more physical interfaces.


and also:


http://www.cisco.com/en/US/docs/ios/iproute/configuration/guide/irp_cfg_eigrp_ps6922_TSD_Products_Configuration_Guide_Chapter.html#wp1054195



Hope to help

Giuseppe



Actions

This Discussion