Routing in Cisco CSS

Unanswered Question
Nov 3rd, 2008

Hi Friends,

I am facing some issues with routing on Cisco CSS. My requirement is that i want to make internal subnets accessible from external network(firewall).

Please have a look at the diagram, i want to reach and subnet reachable from firewall. CSS is configured in routed mode.



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Gilles Dufour Tue, 11/04/2008 - 05:27

what's the concern ??

The CSS will route by default all traffic if not denied by an ACL.


sarabjitmatharu Tue, 11/04/2008 - 13:29

Hi Gilles,

That is the problem i am facing that it is not routing the traffic. I tried this by disabling ACLs also. I am not very good in CSS, so don't know if i have configured something wrong. Please have a look at current configuration.

Gilles Dufour Tue, 11/04/2008 - 23:49

do a 'show circuit' make sure the interfaces are up.

If they are, your CSS is routing and the problem is somewhere else.

Make sure the servers have a default gateway pointing to the CSS.



This Discussion