cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
306
Views
0
Helpful
3
Replies

integrating ccme 4.0 to ccm 4.2

sunnyverghese
Level 1
Level 1

how we can create a dial plan pointing from ccme to ccm , how the digit discarding need to be discard before i send the digit to ccm.

waiting for your valubale reply.

3 Replies 3

jbarcena
Level 9
Level 9

All you need to do is to create a voip dial-peer pointing to the GW that is handling the incoming calls to the CCM, on that GW you should have an incoming dial-peer and an outgoing dial-peer that points to the CCM. Then on CCM you should already have the significant digits on the incoming calls part of the GW config page in the CCMAdmin.

That is all, is actually pretty simple as you can see.

//Jorge

Jaime Valencia
Cisco Employee
Cisco Employee

that completely depends on what you're going to dial and how many digits your dial plan is.

if you create CME as an H323 GW you can configure the inbound digits to X (X is the number of digits your DNs have)

you can configure a translation-rule to strip the digits before sending the call to CUCM

both would do the same, but CCM config is easier

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Rob Huffman
Hall of Fame
Hall of Fame

Hi Sunny,

Just thought I would add this;

This doc shows the integration steps;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmetrans.html#wp1121584

Hope this helps!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: