CRC

Unanswered Question
Nov 3rd, 2008

We can monitor interface errors from Cisco Works.Can we also monitor specifically CRC errors of devices from Cisco Works

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sbilgi Fri, 11/07/2008 - 07:30

You have tomake templates that it gives the CRC error on Cisco Works. For that you have to do folloowing:

RME can send notifications based on syslog messages. If the device is managed in RME and

can generate a syslog message for the error, RME can be configured to send an "automated

action" email. Go to RME > Admin > Syslog Analysis > Define Automated Action.

Click on Add to see a list of supported syslog messages.

DFM polls certain MIBs for fault management and one of these is the

OLD-CISCO-INTERFACES-MIB. The lifTable from that MIB gives CRC and other interace

information.

Actions

This Discussion