job failed in RME Netconfig

Unanswered Question
Nov 4th, 2008
User Badges:

hi

I keep gettnig this error when I run a netconfig job (add commande) in a 3560 switch :


ERROR:RME_CDL1031:Transport session to device failed TFTP: Failed on the device. Unable to create a socket to /10.128.31.37


Anyone know what the cause of this error?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Tue, 11/04/2008 - 15:41
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

It looks like you don't have the proper Netconfig deployment protocols selected under RME > Admin > Config Mgmt > Transport Settings. Either that, or the switch is not reachable by either telnet or SSH from the LMS server.

bdiouf99 Wed, 11/05/2008 - 06:45
User Badges:

hi,

i verify the netconfig deployment protocols in RME and it's OK.


i configure properly the job but i have always this error:

ERROR:RME_CDL1031:Transport session to device failed TFTP: Failed on the device.


what the cause ?


Joe Clarke Wed, 11/05/2008 - 10:10
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

What is your deployment protocol order? What protocol should be used to deploy this config change?

bdiouf99 Fri, 11/07/2008 - 02:08
User Badges:

thank you clarke, i remover "tftp" from the list of protocol used to deploy the config by netcofig. and i use only telnet, so every thing is ok.

thank you!

Actions

This Discussion