iplog default values

Unanswered Question
Nov 5th, 2008



Below are the default values for iplog in AIP-SSM. Does it mean that iplog is inactive because ip-log-packets/bytes is '0', i.e. whichever value is reached first, the iplog stops. Please confirm. Also please advise what are the recommended values for iplog parameters.


ip-log-packets: 0 <defaulted>

ip-log-time: 30 <defaulted>

ip-log-bytes: 0 <defaulted>

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
sadbulali Tue, 11/11/2008 - 07:17

To start IP logging on a virtual sensor, use the iplog command in privileged EXEC mode. Use the no form of this command to disable all logging sessions on a virtual sensor, a particular logging session based on log-id, or all logging sessions.

minutes - Duration the logging should be active, in minutes. Valid range is 1-60. Default is 10 minutes.

numPackets - Total number of packets to log. Valid range is 0-4294967295. Default is 1000 packets. A value of 0 indicates unlimited.

numBytes - Total number of bytes to log. Valid range is 0-4294967295. A value of 0 indicates unlimited


This Discussion