1130 WPA-PSK Radius Mac Authentication

Unanswered Question
Nov 5th, 2008

I am trying to get our Cisco 1130 AP's to use Radius MAC Authentication using a freeradius server. We have been successful with other AP's (Proxim, Netgear) but haven't been able to get the Cisco 1130 to work.

I have attached 2 files. One is the running config, and the other is a debug of radius.

This is what the freeradius log says.

Thu Nov 6 02:48:46 2008 : Auth: Login OK: [004096a3e012/004096a3e012] (from client port 291 cli 00-40-96-A3-E0-12)

I would appreciate any help that anyone is willing to give.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
didyap Tue, 11/11/2008 - 11:32

Use the wpa-psk SSID interface configuration command to configure a pre-shared key for use in WPA authenticated key management. To support WPA on a wireless LAN where 802.1x-based authentication is not available, you must configure a pre-shared key for the SSID.

wpa-psk { hex | ascii } [ 0 | 7 ] encryption-key

but make sure that This command is not supported on bridges.

jaredbaber Thu, 11/13/2008 - 06:19

I get this error.

Error: WPA-PSK not supported with MAC address authentication configured


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode