IPS 4260

Unanswered Question
Nov 6th, 2008
User Badges:

Hi,


I have a IPS 4260 running Version 6.0(5)E2.One of the sensing interface is "UP", but the data is not flowing through. from "show tech-support":

-Missed Packet Percentage = 100


However,the link status is "UP". How is the possible problem, and how i can retify?


thanks in advance.

cash

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rhermes Thu, 11/06/2008 - 08:35
User Badges:
  • Gold, 750 points or more

Was this a working sensor or is this a new install?

For new sensors, I usualy forget to add the sensing interface to the virtual sensor (I;m not sure that'll give you a 100% missed packet stat though). Try these commands:

conf t

service interface

physical-interfaces gigabitEthernet0/1

admin-state enabled

exit

exit

service analysis-engine

virtual-sensor vs0

physical-interface gigabitEthernet0/1


For existing sensors, a reload can clear up many problems.

Actions

This Discussion