11-06-2008 03:48 AM - edited 03-06-2019 02:20 AM
With regards to switch port settings, speed and duplex, for end devices - is best practive to set the speed and duplex or go with auto ?
Thanks
11-06-2008 03:49 AM
Different people have different views to be honest.
Generally speaking i hardcode servers/printers and leave at auto desktops and laptops.
Jon
11-06-2008 04:03 AM
Thanks Jon
11-06-2008 04:28 AM
There are some comments on this page about auto-negotiation:
http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml
I used to hard-code servers & any static devices, however I have had issues with hard-coding due to Server OS & Driver faults. So now unless there is a specific requirement I never hard-code anything.
Andy
11-06-2008 06:11 AM
Thanks Andy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: