11-06-2008 08:40 AM - edited 03-15-2019 02:23 PM
Hi,
I am having an unusual problem in that when I ring into a confernce call, I am prompted to press * then enter the numbner and press * again. The * btuoon is not recognised. I have changed the DTMF relay type on the voice gateway and still no joy. Has anyone come accross these issues before. Below is my dial peer configuration
dial-peer voice 100 pots
destination-pattern 9T
translate-outgoing called 20
direct-inward-dial
port 0/0/0:15
forward-digits all
!
dial-peer voice 2 voip
description **Subscriber**
preference 1
destination-pattern 53...
progress_ind setup enable 3
progress_ind progress enable 8
voice-class codec 1
session target ipv4:10.53.7.11
dtmf-relay h245-signal h245-alphanumeric
no vad
11-06-2008 08:43 AM
what's the call flow on this?? because CUCM does not recognize user input if already on call. are you using unity or something else to route the call??
HTH
java
if this helps, please rate
11-06-2008 08:47 AM
Unity is not involved here
Call flow is
IP Phone calls external conference number ==> call connects ==> user asked to enter * code *
==> When user presses the * key, it is not recognised.
11-06-2008 08:45 AM
Hello,
Is this calling outbound from the call manager into a conference bridge somewhere?
11-06-2008 08:48 AM
yes it is an external conference bridge. The call flow is in the previous thread
11-06-2008 08:50 AM
Hello,
Try entering this command on your gateway:
voice rtp send-recv
Hope that helped, if so please rate.
11-06-2008 08:52 AM
i have already entered this command. It hasn't helped unfortunately
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: