Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
209
Views
0
Helpful
1
Replies

Problem with Caller Display on Internal Handsets

calessandro
Level 1
Level 1

‎11-06-2008 08:40 AM - edited ‎03-15-2019 02:23 PM

Hi All,

I have a CallManager 5.1.2.3000-2 installation where the Caller Display of the Calling Party is NOT displayed until the destination goes off hook - This is between two internal handsets connected to the same cluster.

The user receiving the call only see's the DN displayed on the screen before they pick up the handset, once they do, they see the Caller Display configured on the Calling handset.

They have the problem through the installation, but these results are taken from 2 x 7970 handsets.

Apparently, they used to see the CLID of the calling phone before but I can not confirm this.

Unfortunately I do not have a lab of this level to carry out any testing, so any help is appreciated.

Many Thanks

Colin Alessandro

Labels:
0 Helpful
1 Reply 1

Jaime Valencia
Cisco Employee
Cisco Employee

‎11-06-2008 08:48 AM

configure the alerting name for that, that parameter configures what to show when ringing

Display (Internal Caller ID) is for connected

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate
0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents