Hi I'm trying to configure the HWIC-4SHDSL for 4 pair (eight wire) m-pair mode.
Here is the config.
controller SHDSL 0/0/0
dsl-group 0 pairs 0, 1, 2, 3 m-pair
shdsl rate auto
no ip address
no atm ilmi-keepalive
interface ATM0/0/0.1 point-to-point
ip address 192.168.1.12 255.255.255.0
It seems to work and the controller and ATM show up (see attached). However I cannot ping devices I should be able to int the 192.168.1.x range. The DSLAM shows the line as up also.
Any ideas? i couldn't find any cisco config doc for a 4 pair (eight wire) setup, also the data sheet says that it does it.