SendExecute CiscoIPPhoneError

Unanswered Question
Nov 6th, 2008

I'm trying to a simple CUAE application (using the designer) with a SendExecute. Whenever the SendExecute runs, it fails and the following is placed in the log: Phone was able to process request, but replied with an error: <CiscoIPPhoneError Number="0" />. I've tried various messages and logins, but I always get this error. Can anyone give me any recommendations on how to make this work? Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Richardsonke Fri, 11/07/2008 - 08:56

Got it! This is on a test network and DNS was not set up yet, so the authentication server URL was not working because it had the server's name, rather than IP address in it.


This Discussion