CUCM 6.0.1 - Media Routing through the server

nissarbm_ece · ‎11-06-2008

Hi,

I have CUCM 6.0.1.3000-7 and registered two third party SIP device to the Server.

While I am making the call between these two devices, the media (RTP) is flowing end to end, not through CUCM.

I want to route all the media(RTP) through CUCM. How is it possible?

Keith Fulcher · ‎11-07-2008

Media is always end to end.......even with the phones. Only the signaling is routed to the CUCM. I doubt there is a way to do this.

Jaime Valencia · ‎11-07-2008

CUCM is only a call agent, signaling is stimulus-response. RTP is always between endpoints, that's the whole point of call preservation. if CCM fails, calls are preserved because RTP is between endpoints.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

nissarbm_ece · ‎11-08-2008

Thanks for your response.

With the SCCP supported devices, does the media is routed through the CUCM ?

Jaime Valencia · ‎11-08-2008

no, CUCM does not make media flow-thru

in any protocol

media is between devices. only reason a device sends media to CCM is to use the SW CFB.

if you need that start looking at CUBE

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

nissarbm_ece · ‎11-09-2008

What is thins SW CFB and CUBE?

You have any reference link to these topics?

Jaime Valencia · ‎11-10-2008

Software Conference Bridge

Cisco Unified Border Element

Documentation can be easily found in CCO

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

nissarbm_ece · ‎11-10-2008

Thank you very much for your support.