using network interfaces

Unanswered Question
Nov 6th, 2008

Hi you all

I have this pix 6.3 with interfaces Outside and Inside using the gb-ethernet interfaces.In the Inside interface I have added virtual interfaces for comunicating with the vlan contained in a switch.

But yesterday I decided to activated a fast-ethernet interface. I actvated it & I gave it a routable Ip addres. That made the pix inacsesible in the outside interface.

via cli I shutdown the interface and removed the ip addres. the pix went to normal.

The I tried another expirience, I activated the ehternet interface but this time with a non-routable ip address. I have acces in the outside interface, so I could say it work, but I need to put a routable ip addres not a non-routable ip addres.

Wath shoul I do?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dhananjoy chowdhury Fri, 11/07/2008 - 03:48

try to put a public IP from a IP subnet other than the one being currently used on the Outside interface.

languedoc Fri, 11/07/2008 - 06:23


Of course, I used an ip address from another subnet.



This Discussion