using network interfaces

roussillon · ‎11-06-2008

Hi you all

I have this pix 6.3 with interfaces Outside and Inside using the gb-ethernet interfaces.In the Inside interface I have added virtual interfaces for comunicating with the vlan contained in a switch.

But yesterday I decided to activated a fast-ethernet interface. I actvated it & I gave it a routable Ip addres. That made the pix inacsesible in the outside interface.

via cli I shutdown the interface and removed the ip addres. the pix went to normal.

The I tried another expirience, I activated the ehternet interface but this time with a non-routable ip address. I have acces in the outside interface, so I could say it work, but I need to put a routable ip addres not a non-routable ip addres.

Wath shoul I do?

Thanks

dhananjoy chowdhury · ‎11-07-2008

try to put a public IP from a IP subnet other than the one being currently used on the Outside interface.

roussillon · ‎11-07-2008

Hi

Of course, I used an ip address from another subnet.

Thanks