PBR L3 3750- sdm issue

mkkeyan · ‎11-07-2008

12.2(46)SE IOS

unable to add ip policy route-map ZZZZ in vlan interface. i think problem with sdm.pl advise

Jon Marshall · ‎11-07-2008

To use PBR on the 3750 you have to enable the routing SDM template -

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_46_se/configuration/guide/swsdm.html

Jon

ibrunello · ‎02-07-2009

same problem.

sdm routing template is enabled.

I can configure it, but it behaves strangely:

- when I traceroute from a device behind the PBRed VLAN, with an acl which matches the exact source address, the route-map matches just the first packet (the one with TTL=0), but not the following ones (TTL>1).

route-map rmTEST

match ip address aclMATCH

set ip next-hop 10.10.10.1

any hint?