Testing new CKT

Unanswered Question
Nov 7th, 2008

Could some share their opinion on how to go about testing a new CKT? I am looking for what commands should be used to send large amount of data to test response time, reliability of CKT,..ect.

Thanks in advance,

sK

sK

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tcordier Fri, 11/07/2008 - 09:01

Continous pings with different packet sizes (at least 10000 pings) are valid tests for performance (response time and packet loss) of a new circuit. You should not have more than 1% packet loss (obviously I don't what response time would be acceptable). The only thing you can not perform from the router, is a stresstest (fully load the circuit and observe the performance under full load). This requires specialized equipment and software.

HTH, Thomas

skhirbash Fri, 11/07/2008 - 09:20

Great!

Thanks for the prompt and valuable response Thomas!

sK

Actions

This Discussion