Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
521
Views
0
Helpful
2
Replies

Testing new CKT

skhirbash
Level 1
Level 1

‎11-07-2008 07:56 AM - edited ‎03-04-2019 12:14 AM

Could some share their opinion on how to go about testing a new CKT? I am looking for what commands should be used to send large amount of data to test response time, reliability of CKT,..ect.

Thanks in advance,

sK

sK

Labels:
0 Helpful
2 Replies 2

tcordier
Level 1
Level 1

‎11-07-2008 09:01 AM

Continous pings with different packet sizes (at least 10000 pings) are valid tests for performance (response time and packet loss) of a new circuit. You should not have more than 1% packet loss (obviously I don't what response time would be acceptable). The only thing you can not perform from the router, is a stresstest (fully load the circuit and observe the performance under full load). This requires specialized equipment and software.

HTH, Thomas

0 Helpful

skhirbash
Level 1
Level 1
In response to tcordier

‎11-07-2008 09:20 AM

Great!

Thanks for the prompt and valuable response Thomas!

sK

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card