Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
418
Views
0
Helpful
3
Replies

PIX 515ER upgrade from 6.3(4) to 6.3(5) and PDM

Go to solution
vincent-n
Level 3
Level 3

‎11-09-2008 08:42 PM - edited ‎02-21-2020 03:05 AM

Hi all

I'm in search for documentations on upgrading a PIX515ER v6.3(4) to v6.3(5) and PDM v 3.0(2) to PDM v3.0(4) but can't find them anywhere. Can you please help. Any extra tips on the upgrade process is greatly appreciated.

0 Helpful
1 Accepted Solution

Accepted Solutions
3 Replies 3

Go to solution
vincent-n
Level 3
Level 3
In response to lreger

‎11-09-2008 08:53 PM

Damn, that was quick. Thanks.

0 Helpful

Go to solution
vincent-n
Level 3
Level 3
In response to lreger

‎11-09-2008 09:04 PM

Just another question then regarding the upgrading procedures

1. Disconnect the primary unit and upgrade using 'copy tftp flash'

2. Upgrade PDM following http://www.cisco.com/en/US/docs/security/pix/pix63/pdm30/installation/guide/pdm30CH3.html

3. Power up the primary unit - my question here is what would happen to the standby unit now that it's running 6.3(4) and the primary unit is 6.3(5)?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card