Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
236
Views
0
Helpful
1
Replies

Acknowledge the Problemmessage from the Device behind the ATA

eberle.patrik
Level 1
Level 1

‎11-10-2008 05:23 AM - edited ‎03-15-2019 02:26 PM

My Customer has a Problem with the Cisco Unified Communication Manager and ATA.

In the Customerplace are a installed UCM 6.1 and an ATA186. Behind the ATA is a Analoge Device.

Szenario:

The "Buildinginformationforwarddevice" are connected to an ATA for calling a Number when it gives some Problems. This Works fine. But wenn the call is estabished we want to acknowledge this Call, it will be fail.In the situation the call isn't confirm, the device behind the ATA will be dial the next Number.

The Problem is the acknowledge in this situation. The Confirmation is based on the Dialtones from the Phonebutton's. It's not work internal or extern.

What can be the Problem? Need the ATA a special image?

thx for help

Patrik

Labels:
0 Helpful
1 Reply 1

chaozh
Level 1
Level 1

‎11-14-2008 11:45 AM

Hi Patrik,

I am Chao from ATA team.

Could you try to change SigTimer from default value 0x00000064 to 0x03c00064?

This change will disable ATA's PSTN-LIKE behavior. In your customer's setting, this feature may generate extra 2 ringings at far-end.

Regards,

Chao

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents