UPS Client for Communications Manager Ver 5 / 6

Unanswered Question
Nov 11th, 2008
User Badges:

Does anyone know whether there is a UPS client for the Communications Manager version 5/6? Customers who were on Version 4 had a UPS client installed on the CUCM to power the system down in the event the UPS power is lost

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Aaron Harrison Tue, 11/11/2008 - 08:44
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015


See this excerpt from the CM6.1 OS Admin Guide:

show ups status

This command shows the current status of the USB-connected APC smart-UPS device and starts the monitoring service if not already started.

This command to give full status is only available on 7835-H2 and 7825-H2 servers.

Command Syntax

show ups status

So yes - this doesn't appear in CM5.x so I think it was added in version 6.



Please rate helpful posts.

kallan Tue, 11/11/2008 - 09:26
User Badges:


Thanks for your quick response. I wasn't aware this command existed.

Regards, Keith.


This Discussion