Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
314
Views
9
Helpful
2
Replies

UPS Client for Communications Manager Ver 5 / 6

kallan
Level 1
Level 1

‎11-11-2008 07:49 AM - edited ‎03-18-2019 09:58 PM

Does anyone know whether there is a UPS client for the Communications Manager version 5/6? Customers who were on Version 4 had a UPS client installed on the CUCM to power the system down in the event the UPS power is lost

Labels:
0 Helpful
2 Replies 2

Aaron Harrison
VIP Alumni
VIP Alumni

‎11-11-2008 08:44 AM

Hi

See this excerpt from the CM6.1 OS Admin Guide:

show ups status

This command shows the current status of the USB-connected APC smart-UPS device and starts the monitoring service if not already started.

This command to give full status is only available on 7835-H2 and 7825-H2 servers.

Command Syntax

show ups status

So yes - this doesn't appear in CM5.x so I think it was added in version 6.

Regards

Aaron

Please rate helpful posts.

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

kallan
Level 1
Level 1
In response to Aaron Harrison

‎11-11-2008 09:26 AM

Aaron,

Thanks for your quick response. I wasn't aware this command existed.

Regards, Keith.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents