ASA IPv6 Failover

Unanswered Question

Hi all,

I would like to know if there is any kind of workaround to have Ipv6 in a ASA with an active/standby failover configuration. The problem starts when the secondary ASA becomes Active, because in every “ipv6 enable” interface both link-local and global address are duplicated.

Is there a “manual” workaround to flow IPv6 network traffic by secondary/active ASA ?

Thx in advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion