Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
623
Views
0
Helpful
1
Replies

ASA IPv6 Failover

mserrao
Level 1
Level 1

‎11-11-2008 05:48 PM - edited ‎03-11-2019 07:12 AM

Hi all,

I would like to know if there is any kind of workaround to have Ipv6 in a ASA with an active/standby failover configuration. The problem starts when the secondary ASA becomes Active, because in every “ipv6 enable” interface both link-local and global address are duplicated.

Is there a “manual” workaround to flow IPv6 network traffic by secondary/active ASA ?

Thx in advance

Labels:
0 Helpful
1 Reply 1

tstanik
Level 5
Level 5

‎11-17-2008 03:13 PM

The ASA's failover function does not support IPv6 at this time. Here the Failover Configuration Limitations http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/failover.html#wp1150240

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card