11-13-2008 06:16 AM - edited 03-13-2019 05:50 PM
Hi everybody,
I configured a CMM module (WS-SVC-CMM-ACT) with CCM ver 4.1.3 as a conference bridge and it are properly registered in the CCM.
When I try to make a conference, I have the message âno conference bridgeâ on my phone.
The gigabit and fastethernet port are in same vlan on the switch, but only the gigabithe interface have a IP adresse on the CMM.
Any suggestions?
Solved! Go to Solution.
11-13-2008 12:36 PM
it's just a host address in your subnet, it knows the default gateway from the config
11-13-2008 08:33 AM
make sure the phone has the HW CFB in it's MRGL so it can access it. either device level or device pool MRGL
HTH
java
if this helps, please rate
11-13-2008 09:39 AM
no, I only have my hardware CFB in my MRGL and my CFB it's registred.
11-13-2008 10:33 AM
you will need to configure an ip-address on the ACT Fast Ethernet interface, with a /32 mask
This interface is used for the RTP streams to the CFB
hth
Sascha
11-13-2008 10:40 AM
Hi Sascha,
thanks for your reply.
On the 6500, the gig and fast port are in same vlan. On my CMM card, my int g1/0 have ip 10.0.18.5 255.255.255.0. When I try to configure the fast port with ip on the same vlan 10.0.18.4, I have this error "% 10.0.18.0 overlaps with GigabitEthernet1/0" :)
11-13-2008 12:09 PM
did you configure 10.0.18.4 255.255.255.255 ??
it needs to be a host address, so /32 mask
11-13-2008 12:21 PM
I do not understand. My gig interface have 255.255.255.240 to communicate with default gateway (10.0.18.1). How my fast interface can communicate with CCM if it's configure with /32?
11-13-2008 12:36 PM
it's just a host address in your subnet, it knows the default gateway from the config
11-14-2008 05:33 AM
thanks you very much !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: