ICMP from a specific source address out of multple VLANs

Unanswered Question
Nov 13th, 2008

I am trying to configure PRB from one switch that has multiple IP addresses (multiple vlans). I'd like to source the icmp traffic from the loopback address. Is this feasible?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Tshi M Thu, 11/13/2008 - 07:36

I think that i might have found the solution. You can use:

type echo protocol ipIcmpEcho 1.1.1.1 source-ipaddr 2.2.2.2

under the RTR Base Configuration. I will give it a try.

Actions

This Discussion