11-13-2008 11:20 AM - edited 03-15-2019 02:32 PM
Hi i have a 6.1.2 cluster and i want to setup an ad hoc conference with three phones.If is setup the conference using g722 then it fails , if i use g711 it works.From what i can see this won't work as the software conference bridge in callmanager doesn't support g722.
Is this correct? as i have bee told that when setting up the conference the calls should switch to g711
Any advice would be good.
thanks
mark
11-13-2008 12:15 PM
SW does only support G711.
translation is not done internally, you require XCODER to use G722 with the SW CFB
HTH
java
if this helps, please rate
11-14-2008 01:27 AM
Hi,
Apparently another engineer tested this and when the conference was setup it switched all the streams back to g711 and then back to g722 when the conference ended.
Is this possible as i didn't personally see this happen.
I read through the release notes and it says the software conference bridge supportes g711 and wideband codecs which g722 is one.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: