How to Change Utilization Threshold

Answered Question
Nov 14th, 2008
User Badges:

The current utilization threshold in DFM is at 40% for router's where can this vailue be increased?



Correct Answer by Joe Clarke about 8 years 8 months ago

To increase this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Then, select DFM > System Defined Groups > Interface Groups > Serial, and click Edit. Adjust the Utilization threshold, then click Save, then click OK. Then go to Apply Changes, and apply your changes.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Fri, 11/14/2008 - 08:35
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

To increase this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Then, select DFM > System Defined Groups > Interface Groups > Serial, and click Edit. Adjust the Utilization threshold, then click Save, then click OK. Then go to Apply Changes, and apply your changes.

russnash Fri, 11/14/2008 - 08:38
User Badges:

found it!!! Was in the neighborhood.


thanks for all tour help!!

Actions

This Discussion